Move and delete windows, dors and panes

discussions on 1001bit tools, bugs and ideas

Move and delete windows, dors and panes

Postby Westeco » Mon Dec 06, 2010 1:15 pm

For me the Window, Door and Panes tool works good as long as you leave them where you created them.

When I try to move these items the starting rectangle does not follow the move. On the backside item on the wall seem to move correctly but the there are only one face on the back covering the whole wall including the item.

The only way to delete one of these items I have found is to delete the frame and then delete the edges of the rectangle left on the face.

Any ideas what I do wrong?
Westeco
 
Posts: 3
Joined: Mon Dec 06, 2010 12:45 pm

Re: Move and delete windows, dors and panes

Postby Westeco » Wed Dec 15, 2010 10:13 am

The problem was that I had read too much about cutting and repairing holes for windows and doors in other discussions about windows and doors. When I realized that you must cut and repair holes yourself it works as expected.

Would be nice to have this done by the 1001bit tools.
Westeco
 
Posts: 3
Joined: Mon Dec 06, 2010 12:45 pm

Re: Move and delete windows, dors and panes

Postby GohCH » Mon Jan 24, 2011 2:03 pm

hi Westeco,
Thanks for the comments. I'm currently working on a cut hole, insert windows and doors tool.
Progress has been slow, mainly because of a lot of things happening at the same time....
I'll keep everyone informed once i have something to test out. cheers!
GohCH
 
Posts: 303
Joined: Mon Oct 13, 2008 8:04 am


Return to 1001bit tools

Who is online

Users browsing this forum: No registered users and 1 guest

cron